Whirlpool EV187NYRQ repair
White upright freezer, door shelving. Service for this model across Tampa Bay.

- Model
- EV187NYRQ
- Type
- White upright freezer, door shelving
- Brand
- Whirlpool
About the EV187NYRQ
White finish, door shelving for small packages and an adjustable thermostat characterize the EV187NYRQ, an upright freezer in the EV family. Since endings vary, the label on the cabinet gives us the full number.
Gaskets bear the load of heat and humidity on a garage or porch freezer, so we start at the door. Does it sit flush? Does the seal hold a sheet of paper all the way around? Are loaded bins pulling the door out of line? Then the thermostat and the start parts behind the lower panel get tested. If the cabinet is old enough that a repair would not pay off, we say so first.
What we check on a EV187NYRQ visit
- Door alignment and a paper test around the gasket
- Thermostat and compressor start parts behind the lower panel
- Door bin load pulling the door out of line
Key features
- Upright freezer in the EV family
- Door shelving for small packs
- Adjustable thermostat
- White finish
The model number is on the data label: inside the door frame, on the drawer edge or behind the kick plate. We are an independent repair company, not affiliated with Whirlpool Corporation.
Whirlpool freezer codes
Codes listed for Whirlpool freezers. Which ones a unit can show depends on its control board, so we confirm by the full model number.
Other Whirlpool freezer models
FreezerEH070FXRQChest freezer, manual defrost
FreezerEH150FXRQChest freezer with lift-out basket
FreezerEH185FXTQLarge chest freezer, manual defrost
FreezerEH225FXTQChest freezer with sliding baskets
FreezerEV160NZTQUpright freezer with wire shelves
FreezerEV181NZRQUpright freezer, mechanical control
FreezerEV188NYWQWhite upright freezer, manual defrost
FreezerWZC3115DWChest freezer with sliding basketEV187NYRQ questions
Ice forms along the door edge of my EV187NYRQ. Is the seal to blame?
Possibly. Humid air slipping past a worn gasket freezes at the frame. We check for gaps, door alignment and the hinge, then decide between a seal and an adjustment.
The thermostat clicks, but the compressor does not start. What next?
We test the thermostat for continuity, then the start relay and overload. We quote the result in writing before replacing anything.