Whirlpool E2F40RD045 repair
Dual element electric water heater. Service for this model across Tampa Bay.

- Model
- E2F40RD045
- Type
- Dual element electric water heater
- Brand
- Whirlpool
About the E2F40RD045
A dual element electric storage water heater sold under the Whirlpool name, the E2F40RD045 can show an extra trailing letter on some units, so the label is read in full before ordering. These tanks sit in a garage, closet or attic, wherever the circuit and drain are convenient.
With no hot water, the breaker comes first, then the reset button on the upper thermostat and the voltage at the element terminals. Those steps separate a power problem from a failed element or thermostat. Lukewarm water means testing the lower element and thermostat, which supply most of the heat in a dual element design. A weeping flange gasket and a thermostat no longer touching the tank wall are on the list too.
What we check on a E2F40RD045 visit
- Breaker, reset button and voltage at the element terminals
- Lower element and thermostat for lukewarm water
- Flange gasket weeping, thermostat contact with the tank wall and sediment
Key features
- Electric storage water heater
- Dual element design
- Foam insulation
- Serviceable thermostats and elements
The model number is on the data label: inside the door frame, on the drawer edge or behind the kick plate. We are an independent repair company, not affiliated with Whirlpool Corporation.
Other Whirlpool water heater models
Water HeaterBFG1F4034T3NOVShort gas storage water heater
Water HeaterBFG1H5040T3NOVAtmospheric vent gas water heater
Water HeaterES40R123-45DElectric tank water heater
Water HeaterES40R92-45DLegacy electric water heater
Water HeaterES50R123-45DLarge electric storage water heater
Water HeaterE2F50HD045V Electric Water HeaterDual element electric water heater
Water HeaterFG1H5040T3NOV Gas Water HeaterAtmospheric vent gas water heater
Water HeaterE2F40RD045V Electric Water HeaterDual element electric water heaterE2F40RD045 questions
My E2F40RD045 has no hot water at all. What gets checked?
Breaker, reset button and voltage at the upper thermostat. If power arrives, both elements and thermostats are tested with a meter, so only what failed is replaced.
There is a drip at the element flange. Can it be repaired?
Frequently, with a new gasket or element. If the tank wall is corroded around the opening, replacement is the sensible choice.