Whirlpool GJC3054 repair
Built-in radiant electric cooktop. Service for this model across Tampa Bay.

- Model
- GJC3054
- Type
- Built-in radiant electric cooktop
- Brand
- Whirlpool
About the GJC3054
Radiant elements under a ceramic surface, hot surface lights and rotary controls make up the Whirlpool GJC3054, a built-in electric cooktop of the GJC family. It is an older model that has sat in many counters for years.
An infinite switch cycles a radiant element on and off at middle settings, so we watch how it cycles before replacing anything. We also confirm the hot surface light goes out as the glass cools, look at the painted trim band along the edge, and clean the seal where grease and spills collect. A suffix after the number can change parts, which is why we read the model and serial label first. If an older cooktop is better replaced, we say that.
What we check on a GJC3054 visit
- Element cycling at middle settings
- Hot surface light turning off once the glass cools
- Trim band paint near the edge and the glass seal for debris
Key features
- Built-in electric cooktop
- GJC family ceramic surface
- Radiant elements with hot surface lights
- Rotary controls
The model number is on the data label: inside the door frame, on the drawer edge or behind the kick plate. We are an independent repair company, not affiliated with Whirlpool Corporation.
Whirlpool cooktop codes
Codes listed for Whirlpool cooktops. Which ones a unit can show depends on its control board, so we confirm by the full model number.
Other Whirlpool cooktop models
CooktopGJC3034Built-in electric glass cooktop
CooktopGJC3034GBuilt-in electric cooktop
CooktopGJC3055Built-in electric smooth cooktop
CooktopGJC3055RB30-inch built-in electric cooktop
CooktopGJC365536-inch built-in electric cooktop
CooktopGJC3655RB36-inch built-in electric cooktop
CooktopRC8600XBB30-inch built-in electric cooktop
CooktopRC8608XDQ30-inch electric cooktopGJC3054 questions
Why does my GJC3054 element switch on and off at medium?
That cycling is normal for an infinite switch. If the pauses are long or uneven, the switch contacts may be worn, so we time the cycle and test the switch.
The hot surface light stays on after the glass cools. Why?
It is wired to a sensor or the zone circuit, and a problem in either keeps it lit. We check what controls the light on your variant before quoting.