Whirlpool WUI75X15HW repair
White undercounter ice maker, removable bin. Service for this model across Tampa Bay.

- Model
- WUI75X15HW
- Type
- White undercounter ice maker, removable bin
- Brand
- Whirlpool
About the WUI75X15HW
Flush under the counter sits the WUI75X15HW, a white 15-inch ice maker with a removable bin, and a reversible door on some variants. Door and trim parts can vary by ending, which the label settles.
Because the supply line and drain are tucked out of sight, we slide the unit out far enough to check the line for kinks and the drain for slow flow. The bin and door seal get inspected next. When production is weak, we clean the condenser and test the fan, since a warm cabinet freezes poorly. A bin that sticks or will not seat is corrected too.
What we check on a WUI75X15HW visit
- Supply line kinks and drain flow behind the unit
- Bin seating and door seal
- Condenser cleanliness and fan operation
Key features
- 15-inch undercounter ice maker
- White finish
- Removable ice bin
- Reversible door on equipped variants
The model number is on the data label: inside the door frame, on the drawer edge or behind the kick plate. We are an independent repair company, not affiliated with Whirlpool Corporation.
Whirlpool ice maker codes
Codes listed for Whirlpool ice makers. Which ones a unit can show depends on its control board, so we confirm by the full model number.
Other Whirlpool ice maker models
Ice MakerGI1500XHW15-inch undercounter ice maker
Ice MakerGI15NDXTBBlack 15-inch undercounter ice maker
Ice MakerGI15NDXXQ15-inch undercounter cube ice maker
Ice MakerGI15NDXZSStainless 15-inch undercounter ice maker
Ice MakerGI15NFLXSLeft-hinge stainless undercounter ice maker
Ice MakerGI15NFRXSRight-hinge stainless undercounter ice maker
Ice MakerWUI75X15HBBlack clear-ice undercounter ice maker
Ice MakerWUI75X15HZStainless clear-ice maker with drain pumpWUI75X15HW questions
My ice maker quit after I pushed the bin back in. Why?
A bin not fully seated can interrupt the level sensor or stop the door closing. We reseat it, check the sensor and watch for a new cycle.
What sits behind the machine that can cause trouble?
The water supply line and the drain. A kink or loose fitting cuts flow or leaks onto the floor, so we move the unit carefully and inspect both.