Whirlpool WEG515S0LB repair
Gas slide-in range. Service for this model across Tampa Bay.

- Model
- WEG515S0LB
- Type
- Gas slide-in range
- Brand
- Whirlpool
About the WEG515S0LB
Gas fuel and slide-in styling are what we confirm for the WEG515S0LB, which is also sold as WEG515S0LB0, WEG515S0LB1 and WEG515S0LB3. Other letters ahead of the last digits can mean a different finish, and we assume no further features until we see the range.
A slide-in sits flush between countertops, so we start by looking at how it is positioned, whether the gas connector is kinked and whether the anti-tip bracket is engaged. Only then do we turn to burner ignition, flame color, the oven bake igniter and the gas valve. Knobs and switches get a feel test. Parts are matched against the full label, never the shortened number.
What we check on a WEG515S0LB visit
- Range position, gas connector and anti-tip bracket
- Burner ignition, flame color and bake igniter draw
- Gas valve response, knobs and switches
Key features
- Gas range
- Slide-in style
- Sold with the endings LB0, LB1 and LB3, and others
The model number is on the data label: inside the door frame, on the drawer edge or behind the kick plate. We are an independent repair company, not affiliated with Whirlpool Corporation.
Whirlpool range codes
Codes listed for Whirlpool ranges. Which ones a unit can show depends on its control board, so we confirm by the full model number.
Other Whirlpool range models
RangeWEG515S0FV30-inch gas slide-in range
RangeWEG750H0HBGas slide-in range
RangeWEG995H0FSlide-in gas range
RangeWEGA25H0HNGas slide-in range
RangeWFC110M0AW30-inch coil electric range
RangeWFC130M0AWWhite coil electric range, manual-clean
RangeWFC150M0EBFreestanding electric range
RangeWFC150M0JBFreestanding electric rangeWEG515S0LB questions
Why does the ending on WEG515S0LB matter?
The last digits and the letters before them mark a finish or revision. Knobs, switches and trim can differ, so we read the full label before ordering.
My burner lights, but the flame is yellow and uneven. Why?
A partly blocked port or a misseated cap is the likely cause. We clean the port, reseat the parts and check the air mixture before looking at the valve.