Whirlpool W10719730A repair
Freestanding electric range. Service for this model across Tampa Bay.

- Model
- W10719730A
- Type
- Freestanding electric range
- Brand
- Whirlpool
About the W10719730A
W10719730A is a Whirlpool freestanding electric range, listed under that single number. Before ordering parts we read the label on the range, so what we hold matches what you own.
The range plugs into a 240-volt outlet and stands on the floor, so it is easy to pull out for service. Surface elements, their switches and the oven elements account for the calls, and we test them in turn with a meter. If an element glows unevenly or burns out in spots, its terminal and the receptacle where it plugs in get a close look. For the oven we compare the cavity with a thermometer, then check the sensor, door gasket and hinge alignment.
What we check on a W10719730A visit
- Surface element heating and the infinite switch response
- Bake and broil element continuity, plus temperature sensor readings
- Door gasket and hinge alignment
Key features
- Electric range
- Freestanding installation
- Surface elements with an oven below
The model number is on the data label: inside the door frame, on the drawer edge or behind the kick plate. We are an independent repair company, not affiliated with Whirlpool Corporation.
Whirlpool range codes
Codes listed for Whirlpool ranges. Which ones a unit can show depends on its control board, so we confirm by the full model number.
Other Whirlpool range models
RangeWEG515S0FV30-inch gas slide-in range
RangeWEG515S0LBGas slide-in range
RangeWEG750H0HBGas slide-in range
RangeWEG995H0FSlide-in gas range
RangeWEGA25H0HNGas slide-in range
RangeWFC110M0AW30-inch coil electric range
RangeWFC130M0AWWhite coil electric range, manual-clean
RangeWFC150M0EBFreestanding electric rangeW10719730A questions
One coil glows only in spots. Is it finished?
The coil has probably worn out, but we also check the receptacle it plugs into. A burned receptacle can ruin a new coil, so we replace both when needed.
My oven takes forever to heat. What do you test?
A meter on the bake element, the sensor against a thermometer and a look at the door seal for leaking heat. Any one of the three can slow an oven.
Can you service it without moving it far?
Most tests happen in place. We pull the range out only for rear connections and set it back square with the anti-tip bracket engaged.