Whirlpool WFE535S0LS repair
Freestanding electric range. Service for this model across Tampa Bay.

- Model
- WFE535S0LS
- Type
- Freestanding electric range
- Brand
- Whirlpool
About the WFE535S0LS
Endings for the WFE535S0LS run LS0, LS2 and LS3 among others, and it is an electric freestanding range. The final digits can change which control or element fits, so we read them off the plate and not an old receipt.
Ranges like this get replaced during a remodel, though they remain repairable. Nearly every call ends at an element, a switch, a sensor or the control, each testable at your home in one visit. Steady power comes first, then elements, then the oven read against a thermometer while we watch how the control cycles. A weak broil is traced to its element and wiring, and the terminal block is checked.
What we check on a WFE535S0LS visit
- Power supply at the terminal block
- Cooktop element heating
- Bake element and thermostat behavior, broil output and electronic control display
Key features
- Electric freestanding range
- Floor-standing design
- Other endings: WFE535S0LS0, WFE535S0LS2, WFE535S0LS3
The model number is on the data label: inside the door frame, on the drawer edge or behind the kick plate. We are an independent repair company, not affiliated with Whirlpool Corporation.
Whirlpool range codes
Codes listed for Whirlpool ranges. Which ones a unit can show depends on its control board, so we confirm by the full model number.
Other Whirlpool range models
RangeWEG515S0FV30-inch gas slide-in range
RangeWEG515S0LBGas slide-in range
RangeWEG750H0HBGas slide-in range
RangeWEG995H0FSlide-in gas range
RangeWEGA25H0HNGas slide-in range
RangeWFC110M0AW30-inch coil electric range
RangeWFC130M0AWWhite coil electric range, manual-clean
RangeWFC150M0EBFreestanding electric rangeWFE535S0LS questions
Why does my range broil weakly?
A broil element that has lost output, or loose wiring to it. We meter the element and check connections before suggesting any part.
Should I replace the control or the range?
That depends on the quote. We test the control and wiring first, give a written price, and say so when repair cost nears a new range.