Whirlpool WFG110AVQ repair
30-inch freestanding gas range. Service for this model across Tampa Bay.

- Model
- WFG110AVQ
- Type
- 30-inch freestanding gas range
- Brand
- Whirlpool
About the WFG110AVQ
WFG110AVQ is a gas range, 30 inches wide, with four sealed burners on top and a manual-clean oven below. A few versions include a broiler drawer. As a gas appliance it depends on a supply line and a regulator, which changes the service picture compared with an electric stove.
We begin on the cooktop. Each burner should light and settle into a steady blue flame, so we inspect the ports and listen for the igniter clicking. Inside the oven, the igniter must glow strongly enough to open the safety valve, and a dim one is a familiar reason for a cold oven. We also test the gas connection and regulator for leaks and compare oven temperature to the dial. Parts follow the plate on your range.
What we check on a WFG110AVQ visit
- Burner lighting, flame color and port cleanliness on all four sealed burners
- Oven igniter glow against what the safety valve needs to open
- Gas connection and regulator for leaks, then oven heat against the dial
Key features
- Gas range, 30 inches wide
- Four sealed cooktop burners
- Oven cleaned by hand, no self-clean cycle
- Broiler drawer included on certain versions
The model number is on the data label: inside the door frame, on the drawer edge or behind the kick plate. We are an independent repair company, not affiliated with Whirlpool Corporation.
Whirlpool range codes
Codes listed for Whirlpool ranges. Which ones a unit can show depends on its control board, so we confirm by the full model number.
Other Whirlpool range models
RangeWEG515S0FV30-inch gas slide-in range
RangeWEG515S0LBGas slide-in range
RangeWEG750H0HBGas slide-in range
RangeWEG995H0FSlide-in gas range
RangeWEGA25H0HNGas slide-in range
RangeWFC110M0AW30-inch coil electric range
RangeWFC130M0AWWhite coil electric range, manual-clean
RangeWFC150M0EBFreestanding electric rangeWFG110AVQ questions
The gas oven stays cold. What do you test first?
The igniter comes first. A dim glow may leave the safety valve closed, so we read the current it pulls, inspect the valve and confirm gas is reaching the range before anything gets replaced.
A burner ticks but never catches. Why?
Clogged ports, or an igniter that is dirty or sitting off-center, are the leading suspects. We clean the burner, try it again, and replace parts only if it still refuses to light.
Is a leak check part of the service?
Yes, each visit includes the connection and regulator. If a leak turns up, we tell you immediately and it gets corrected before the range is used again.