Whirlpool WFG231LVQ repair
30-inch open-burner gas range. Service for this model across Tampa Bay.

- Model
- WFG231LVQ
- Type
- 30-inch open-burner gas range
- Brand
- Whirlpool
About the WFG231LVQ
On the WFG231LVQ, a freestanding gas range 30 inches wide, the burners are exposed rather than sealed beneath caps. The oven is a hand-cleaned design, and a storage drawer sits below it. Exposed burners let spills reach the ports faster, so ports need more frequent attention.
We therefore inspect the ports before anything else. A flame that comes out yellow, ragged or lopsided tells us to clear them before replacing parts; after that, each burner gets its igniter and switch tested. Oven checks cover igniter, gas valve and temperature accuracy. The drawer gets a glance for bent rails, since loose items beside the burner box invite trouble. Your label decides which parts we order.
What we check on a WFG231LVQ visit
- Port cleanliness and flame color on each exposed burner
- Spark and switch action at every burner once cleaned
- Oven igniter, gas valve and temperature, plus drawer rails and the gas fitting
Key features
- Freestanding gas range, 30-inch width
- Exposed open burners
- Hand-cleaned oven
- Drawer for storage below the oven
The model number is on the data label: inside the door frame, on the drawer edge or behind the kick plate. We are an independent repair company, not affiliated with Whirlpool Corporation.
Whirlpool range codes
Codes listed for Whirlpool ranges. Which ones a unit can show depends on its control board, so we confirm by the full model number.
Other Whirlpool range models
RangeWEG515S0FV30-inch gas slide-in range
RangeWEG515S0LBGas slide-in range
RangeWEG750H0HBGas slide-in range
RangeWEG995H0FSlide-in gas range
RangeWEGA25H0HNGas slide-in range
RangeWFC110M0AW30-inch coil electric range
RangeWFC130M0AWWhite coil electric range, manual-clean
RangeWFC150M0EBFreestanding electric rangeWFG231LVQ questions
The flame on one burner is yellow and uneven. Should I worry?
Blocked ports or poor air mixing can cause that look. We clean the burner and tune its air mix; should the flame still look poor, the valve and gas supply are next.
How should open burners be kept up?
Clean them regularly, since spills fall straight onto the ports. A soft brush and a pin free many clogs, and we do this during testing when it applies.
Does the drawer need repair work?
Only when its rails are damaged. It sits close to the burner box, so we look it over and make sure nothing flammable is stored inside.