Whirlpool WFG710H0AS repair
30-inch freestanding gas range. Service for this model across Tampa Bay.

- Model
- WFG710H0AS
- Type
- 30-inch freestanding gas range
- Brand
- Whirlpool
About the WFG710H0AS
WFG710H0AS is a 30-inch freestanding gas range with sealed burners and continuous cast-iron grates, and a convection oven on some versions. The label decides which fan and parts apply; the number is sometimes written with a trailing digit, as in WFG710H0AS0.
Sealed burners hold spills on the cooktop, and continuous grates let you slide a pan between burners. The service tradeoff is that spills reach the cap and electrode, which explains clicking after the flame lights or an uneven flame. We clean and dry the burner, then test the spark. An igniter that glows without gas lighting gets a current test. If the oven smells of gas at first start, turn it off, leave the room and call us before using it again.
What we check on a WFG710H0AS visit
- Burner clicking after the flame has lit
- Oven igniter glowing without gas lighting
- Uneven flame on a single burner, plus any gas odor at first start
Key features
- 30-inch freestanding gas range
- Sealed burners
- Continuous cast-iron grates
- Convection oven on certain versions
The model number is on the data label: inside the door frame, on the drawer edge or behind the kick plate. We are an independent repair company, not affiliated with Whirlpool Corporation.
Whirlpool range codes
Codes listed for Whirlpool ranges. Which ones a unit can show depends on its control board, so we confirm by the full model number.
Other Whirlpool range models
RangeWEG515S0FV30-inch gas slide-in range
RangeWEG515S0LBGas slide-in range
RangeWEG750H0HBGas slide-in range
RangeWEG995H0FSlide-in gas range
RangeWEGA25H0HNGas slide-in range
RangeWFC110M0AW30-inch coil electric range
RangeWFC130M0AWWhite coil electric range, manual-clean
RangeWFC150M0EBFreestanding electric rangeWFG710H0AS questions
My burner clicks after the flame is lit. Why?
Moisture or residue on a sealed burner can keep the spark switch active. We clean and dry the cap and electrode, then test the switch, replacing a part only if cleaning does not stop the clicking.
The igniter glows but the oven will not light. What happens?
We measure the igniter current. If it is too low, the gas valve will not open fully, and a weak igniter is replaced once you have the price in writing.
Is a gas smell at first oven start normal?
A brief odor on a first start can happen, but it should not linger. Turn the oven off and leave the area; if the smell returns, call us before using it so we can test the igniter and connections.