Whirlpool WHE33311 repair
Freestanding electric range. Service for this model across Tampa Bay.

- Model
- WHE33311
- Type
- Freestanding electric range
- Brand
- Whirlpool
About the WHE33311
The WHE33311 is a freestanding electric range fed by a dedicated 240-volt line at the back. It is a familiar setup in older homes and in rentals where the stove is expected to last.
We start with whatever is easiest to rule out. Surface elements and their receptacles get tested, then the infinite switches behind the knobs. In the oven we measure the bake element and look at the sensor and relay. Heat marks near a terminal show that a connection has been loose for a while and should be replaced along with the element. The model and serial label is copied first so parts match the revision, and when a range has reached the end of its useful life, we say so.
What we check on a WHE33311 visit
- Surface unit that heats on only one setting
- Burner receptacle with discolored or loose terminals
- Oven that preheats very slowly, and a knob that spins without engaging its switch
Key features
- Electric range
- Freestanding
- Runs on a 240-volt circuit
The model number is on the data label: inside the door frame, on the drawer edge or behind the kick plate. We are an independent repair company, not affiliated with Whirlpool Corporation.
Whirlpool range codes
Codes listed for Whirlpool ranges. Which ones a unit can show depends on its control board, so we confirm by the full model number.
Other Whirlpool range models
RangeWEG515S0FV30-inch gas slide-in range
RangeWEG515S0LBGas slide-in range
RangeWEG750H0HBGas slide-in range
RangeWEG995H0FSlide-in gas range
RangeWEGA25H0HNGas slide-in range
RangeWFC110M0AW30-inch coil electric range
RangeWFC130M0AWWhite coil electric range, manual-clean
RangeWFC150M0EBFreestanding electric rangeWHE33311 questions
My burner heats only on high. Is it the switch?
Quite possibly. A burner switch that loses its middle settings may send power only at full. We test the switch and element and replace whichever does not measure correctly.
What harm does a loose burner receptacle do?
Weak heat, and it can scorch the wiring. We replace the receptacle and any damaged wire ends along with the element when needed.
Can this range be fixed in a single visit?
Many element, switch and receptacle repairs are done in one visit when we have the part. We read the label first and tell you before work if a part must be ordered.