Whirlpool WHP54802 repair
Freestanding electric range. Service for this model across Tampa Bay.

- Model
- WHP54802
- Type
- Freestanding electric range
- Brand
- Whirlpool
About the WHP54802
WHP54802 is an electric range of the freestanding style, built to go anywhere along a kitchen run that has the proper outlet. Around Tampa Bay that can mean a rental unit or a kitchen where the range has already been replaced once or twice.
When the oven ignores a setting, we separate the control from the power side. A display and keypad can work while the elements receive nothing, so we take readings from the terminal block through the element and relay. If bake fails while broil works, the bake element or its circuit gets our attention first. Control boards on this range do not swap between revisions, so we copy the model and serial label first. If it is past repairing, we tell you honestly.
What we check on a WHP54802 visit
- Oven that does nothing after a temperature is entered
- Broil that works while bake stays dead
- Loose burner knob, and a display that flickers or goes blank
Key features
- Electric range
- Freestanding
- 240-volt household supply
The model number is on the data label: inside the door frame, on the drawer edge or behind the kick plate. We are an independent repair company, not affiliated with Whirlpool Corporation.
Whirlpool range codes
Codes listed for Whirlpool ranges. Which ones a unit can show depends on its control board, so we confirm by the full model number.
Other Whirlpool range models
RangeWEG515S0FV30-inch gas slide-in range
RangeWEG515S0LBGas slide-in range
RangeWEG750H0HBGas slide-in range
RangeWEG995H0FSlide-in gas range
RangeWEGA25H0HNGas slide-in range
RangeWFC110M0AW30-inch coil electric range
RangeWFC130M0AWWhite coil electric range, manual-clean
RangeWFC150M0EBFreestanding electric rangeWHP54802 questions
Broil works on my range but bake does not. Why?
The two elements are separate parts on their own circuits. A failed bake element, a bad connection to it or the relay powering it is the likely cause, so we test each in order.
My display went blank. Is the board dead?
Not always. Loose connectors, a weak power supply or a failing board can each blank a display. We check supply voltage and connections before proposing a new board.
Can you get parts for older freestanding ranges?
We order the part once the label is read. Elements, switches and knobs are generally still obtainable for older ranges, and the quote is written before anything is ordered.