Whirlpool WSGS5030SB repair
Slide-in gas range. Service for this model across Tampa Bay.

- Model
- WSGS5030SB
- Type
- Slide-in gas range
- Brand
- Whirlpool
About the WSGS5030SB
WSGS5030SB is a slide-in gas range. The cooktop edge overlaps the countertops and the controls sit on the front instead of a back panel. The fit looks neat, but the range must be removed carefully so the counter edge and gas line are not damaged.
We begin with burners and ignition, then the oven igniter and safety valve. Front controls sit close to heat and spills, so knob and switch condition gets a look. After pulling the range out, we test the gas fitting for leaks and make sure the bracket is seated before it goes back in. Three endings are known for this number: SB0, SW0 and SZ0. The model and serial label tells us your color and revision, so parts match.
What we check on a WSGS5030SB visit
- Burner ignition that clicks without lighting
- Oven igniter that glows but does not light the burner
- Front knobs that feel loose, plus gaps along the counter edge after the range is moved
Key features
- Gas range
- Slide-in design
- Color and revision codes: WSGS5030SB0, WSGS5030SW0, WSGS5030SZ0
The model number is on the data label: inside the door frame, on the drawer edge or behind the kick plate. We are an independent repair company, not affiliated with Whirlpool Corporation.
Whirlpool range codes
Codes listed for Whirlpool ranges. Which ones a unit can show depends on its control board, so we confirm by the full model number.
Other Whirlpool range models
RangeWEG515S0FV30-inch gas slide-in range
RangeWEG515S0LBGas slide-in range
RangeWEG750H0HBGas slide-in range
RangeWEG995H0FSlide-in gas range
RangeWEGA25H0HNGas slide-in range
RangeWFC110M0AW30-inch coil electric range
RangeWFC130M0AWWhite coil electric range, manual-clean
RangeWFC150M0EBFreestanding electric rangeWSGS5030SB questions
Does a slide-in gas range cost more to repair than a freestanding one?
Parts are similar, but removing it is slower since the sides fit tightly against the counters. We protect floor and counter edge and test the gas connection after reinstalling.
All burners click but one will not light. Why?
A blocked port, a damp cap or a shifted spark electrode can stop one burner. We clean and realign it, then test the module if the problem continues.
Why check the anti-tip bracket on a slide-in?
The range is pulled out and pushed back during service, so we confirm the bracket still catches it. That prevents tipping when the oven door carries weight.