Whirlpool YWEE515S0LB repair
Slide-in electric range. Service for this model across Tampa Bay.

- Model
- YWEE515S0LB
- Type
- Slide-in electric range
- Brand
- Whirlpool
About the YWEE515S0LB
The YWEE515S0LB is an electric slide-in range that fits flush between cabinets, with front controls and an outlet behind. We handle it carefully because of the counter edges on both sides.
If heating stops once the door closes completely, the door switch or latch circuit becomes a suspect alongside the control. A cooktop element that stays warm after the knob is off suggests a switch, and a burn mark near the bake connector shows the terminal has been running hot. Touch controls that behave inconsistently are tested at the panel before any board is considered. Endings such as LB0, LS3 and LV2 are part of a longer list, so the label on your range comes first.
What we check on a YWEE515S0LB visit
- Door switch and latch circuit when heating stops with the door fully shut
- Cooktop element that stays warm after the knob is off
- Burn marks at the bake connector, and touch control response
Key features
- Electric range
- Slide-in style
- Finish and revision codes include YWEE515S0LB0, YWEE515S0LS3, YWEE515S0LV2
The model number is on the data label: inside the door frame, on the drawer edge or behind the kick plate. We are an independent repair company, not affiliated with Whirlpool Corporation.
Whirlpool range codes
Codes listed for Whirlpool ranges. Which ones a unit can show depends on its control board, so we confirm by the full model number.
Other Whirlpool range models
RangeWEG515S0FV30-inch gas slide-in range
RangeWEG515S0LBGas slide-in range
RangeWEG750H0HBGas slide-in range
RangeWEG995H0FSlide-in gas range
RangeWEGA25H0HNGas slide-in range
RangeWFC110M0AW30-inch coil electric range
RangeWFC130M0AWWhite coil electric range, manual-clean
RangeWFC150M0EBFreestanding electric rangeYWEE515S0LB questions
My oven stops heating when the door is shut. Why?
The door switch, the latch or the control may be breaking the heating circuit. We test the switch and latch before looking at the board.
A cooktop element stays warm after I switch it off. Is that dangerous?
It can mean a stuck switch holding power on. Turn off the range breaker until we test the switch, and we replace it if the contacts have stuck.
What does a burn mark at the bake connector mean?
The terminal has been resisting current and running hot. We replace the element and connector together so the new part does not fail the same way.