Whirlpool YWEE745H0FE repair
Slide-in electric range. Service for this model across Tampa Bay.

- Model
- YWEE745H0FE
- Type
- Slide-in electric range
- Brand
- Whirlpool
About the YWEE745H0FE
YWEE745H0FE is an electric slide-in range with front controls, sold under finish and revision suffixes such as YWEE745H0FE0, YWEE745H0FH1 and YWEE745H0FS2. We read the complete label before ordering anything.
We avoid assuming features the label does not state. For service the question is which oven modes work: if bake heats and broil does not, the broil element and its relay get tested; if the display is alive but refuses entries, the panel and control are checked. Uneven glow at the cooktop sends us to the element and receptacle. Behind the range, we look at the supply connection, the cord and the bracket, and any scorching at the terminals gets repaired before the range is set back.
What we check on a YWEE745H0FE visit
- Bake working while broil does not: element, relay and wiring
- Cooktop zone with dim or uneven glow
- Display that responds but refuses entries, and scorched rear connections
Key features
- Electric range
- Slide-in style with front controls
- Finish and revision codes include YWEE745H0FE0, YWEE745H0FH1, YWEE745H0FS2
The model number is on the data label: inside the door frame, on the drawer edge or behind the kick plate. We are an independent repair company, not affiliated with Whirlpool Corporation.
Whirlpool range codes
Codes listed for Whirlpool ranges. Which ones a unit can show depends on its control board, so we confirm by the full model number.
Other Whirlpool range models
RangeWEG515S0FV30-inch gas slide-in range
RangeWEG515S0LBGas slide-in range
RangeWEG750H0HBGas slide-in range
RangeWEG995H0FSlide-in gas range
RangeWEGA25H0HNGas slide-in range
RangeWFC110M0AW30-inch coil electric range
RangeWFC130M0AWWhite coil electric range, manual-clean
RangeWFC150M0EBFreestanding electric rangeYWEE745H0FE questions
The oven bakes but will not broil. What is tested?
Broil has its own element and relay. We test element resistance, relay output and the wiring between them, replacing only what has failed.
The display responds but the oven ignores my entry. Why?
The panel may send signals the control does not accept, or the control may be holding back heat. We test the panel connection and the control outputs.
What do you inspect behind a slide-in range?
The supply connection, cord and bracket. Scorching at the terminals tells us the connection has been resisting current.