Whirlpool YWEE745H0LZ repair
Slide-in electric range. Service for this model across Tampa Bay.

- Model
- YWEE745H0LZ
- Type
- Slide-in electric range
- Brand
- Whirlpool
About the YWEE745H0LZ
With suffixes YWEE745H0LZ0, YWEE745H0LZ1 and YWEE745H0LZ3 on record, the YWEE745H0LZ is an electric slide-in range. It has the flush fit, front controls and rear power connection that define the type.
A noise that grows over several weeks tends to trace back to a fan motor or its housing, so we listen with the oven running and then inspect the fan and vents. A cooktop zone slow to heat is checked for element wear and a weak connection. When a control locks up after an outage, we test the supply and the board response before suggesting any replacement. A door that will not close squarely against the frame gets a hinge inspection too.
What we check on a YWEE745H0LZ visit
- Fan or cooling noise, traced to the motor, blades or vents
- Slow cooktop zone: element wear and connection
- Control that locks up after a power interruption
Key features
- Electric range
- Slide-in style
- Revision codes YWEE745H0LZ0, YWEE745H0LZ1, YWEE745H0LZ3
The model number is on the data label: inside the door frame, on the drawer edge or behind the kick plate. We are an independent repair company, not affiliated with Whirlpool Corporation.
Whirlpool range codes
Codes listed for Whirlpool ranges. Which ones a unit can show depends on its control board, so we confirm by the full model number.
Other Whirlpool range models
RangeWEG515S0FV30-inch gas slide-in range
RangeWEG515S0LBGas slide-in range
RangeWEG750H0HBGas slide-in range
RangeWEG995H0FSlide-in gas range
RangeWEGA25H0HNGas slide-in range
RangeWFC110M0AW30-inch coil electric range
RangeWFC130M0AWWhite coil electric range, manual-clean
RangeWFC150M0EBFreestanding electric rangeYWEE745H0LZ questions
The fan is getting louder. What should be done?
A louder fan points to a worn motor, a loose blade or a blocked vent. We run the oven, locate the sound and clean or replace the affected part.
Why does the control freeze after an outage?
An outage can leave the board in an odd state or damage a relay. We test the supply and reset behavior first, and propose a new board only if it will not recover.
Can an out-of-square door be fixed?
In many cases, yes. Worn hinges or a bent hinge arm are the cause, and we replace the worn parts, then check gasket contact all the way around.