Whirlpool YWFE775H0HB repair
Freestanding electric range. Service for this model across Tampa Bay.

- Model
- YWFE775H0HB
- Type
- Freestanding electric range
- Brand
- Whirlpool
About the YWFE775H0HB
YWFE775H0HB is a freestanding electric range found in single-family kitchens, where it has stood in one spot for a long time with a 240-volt outlet behind it and a cabinet gap on each side.
This type has several surface switches and an oven control, so a service call comes down to which part of the range is off. If the cooktop gives only high heat, we examine the burner switch. If an element sparks, we pull it and check the receptacle for burned contacts. If the oven drifts from the set temperature, we compare the sensor with a thermometer and look at the control. Endings YWFE775H0HB0, YWFE775H0HB1 and YWFE775H0HB2 are listed, and the plate tells us which applies.
What we check on a YWFE775H0HB visit
- Oven temperature drifting from the dial or display
- Element that sparks or buzzes when the burner comes on
- Cooktop switch giving only high heat, plus door hinge and latch hold
Key features
- Electric range
- Freestanding
- Revision endings YWFE775H0HB0, YWFE775H0HB1, YWFE775H0HB2
The model number is on the data label: inside the door frame, on the drawer edge or behind the kick plate. We are an independent repair company, not affiliated with Whirlpool Corporation.
Whirlpool range codes
Codes listed for Whirlpool ranges. Which ones a unit can show depends on its control board, so we confirm by the full model number.
Other Whirlpool range models
RangeWEG515S0FV30-inch gas slide-in range
RangeWEG515S0LBGas slide-in range
RangeWEG750H0HBGas slide-in range
RangeWEG995H0FSlide-in gas range
RangeWEGA25H0HNGas slide-in range
RangeWFC110M0AW30-inch coil electric range
RangeWFC130M0AWWhite coil electric range, manual-clean
RangeWFC150M0EBFreestanding electric rangeYWFE775H0HB questions
My burner seems to run only on high. What is wrong?
A burner switch that no longer steps through heat settings is a frequent cause on an electric range. We test the switch contacts and the element and replace only the part that fails.
An element sparks when it turns on. Is it safe to keep using?
Turn it off and do not use that burner. Sparking points to a worn element end or burned receptacle, and we inspect both and replace what is damaged first.
Does the ending change the parts?
It can. HB0, HB1 and HB2 mark revisions, and a control or switch may differ between them, so we confirm the complete label before ordering.