Whirlpool YWFES5030RB repair
Free-standing electric range. Service for this model across Tampa Bay.

- Model
- YWFES5030RB
- Type
- Free-standing electric range
- Brand
- Whirlpool
About the YWFES5030RB
YWFES5030RB is a free-standing electric range that stands on the floor, plugs into a 240-volt wall outlet and has the elements on top with the oven below. Kitchens that have not been remodeled in years may hold one.
We approach it by comparing one burner against another. If one element glows dimmer than the rest, or needs the knob held at a certain spot, the switch or receptacle is a likelier cause than the element. In the oven, a swing where temperature overshoots and then falls well below the setting makes us look at the sensor and control before replacing the element. Four endings are listed, among them YWFES5030RB0, YWFES5030RV0 and YWFES5030RW0.
What we check on a YWFES5030RB visit
- Element that stays dim while the others glow bright
- Oven that overshoots, then cools well below the set point
- Receptacle loose in the cooktop, plus a knob that must be held in position to heat
Key features
- Free-standing electric range
- Also sold as YWFES5030RB0, YWFES5030RV0, YWFES5030RW0
- Four listed revision endings
- 240-volt household supply
The model number is on the data label: inside the door frame, on the drawer edge or behind the kick plate. We are an independent repair company, not affiliated with Whirlpool Corporation.
Whirlpool range codes
Codes listed for Whirlpool ranges. Which ones a unit can show depends on its control board, so we confirm by the full model number.
Other Whirlpool range models
RangeWEG515S0FV30-inch gas slide-in range
RangeWEG515S0LBGas slide-in range
RangeWEG750H0HBGas slide-in range
RangeWEG995H0FSlide-in gas range
RangeWEGA25H0HNGas slide-in range
RangeWFC110M0AW30-inch coil electric range
RangeWFC130M0AWWhite coil electric range, manual-clean
RangeWFC150M0EBFreestanding electric rangeYWFES5030RB questions
Why does one burner glow dimmer than the rest?
A worn coil, a poor receptacle contact or a switch sending only part of the power could be responsible. We compare resistance and inspect the terminals to see which it is.
What causes oven temperature swings?
A drifting sensor, or a control that cycles the element too early or too late. We test the sensor value against a thermometer before replacing any part.
Do all four endings share parts?
Many parts are shared, but revisions can change switches or controls. We read the label for the exact ending and match parts to it rather than assuming.