Whirlpool YWFES7030SW repair
Free-standing electric range. Service for this model across Tampa Bay.

- Model
- YWFES7030SW
- Type
- Free-standing electric range
- Brand
- Whirlpool
About the YWFES7030SW
Listed with two endings, YWFES7030SW0 and YWFES7030SZ0, the YWFES7030SW is a free-standing electric range on a 240-volt supply with no gas line, so every heat source on it is an electric element.
Control wear is what brings us to a range like this. A knob with a loose stem can turn without moving the switch behind it. A cooktop element that stays hot after shutoff may have a stuck switch, and we treat that as a safety matter: power goes off at the breaker and the switch is tested before the burner is used again. In the oven we confirm bake and broil elements take turns, since an oven running on only one element heats slowly. The plate shows which ending you have, and we order to match.
What we check on a YWFES7030SW visit
- Cooktop that stays hot after the knob is turned off
- Oven preheating on only one element
- Burner knob with a loose or spinning stem, plus a cooling fan that runs long after use
Key features
- Free-standing electric range
- Also sold as YWFES7030SW0 and YWFES7030SZ0
- Plugs into a 240-volt outlet
The model number is on the data label: inside the door frame, on the drawer edge or behind the kick plate. We are an independent repair company, not affiliated with Whirlpool Corporation.
Whirlpool range codes
Codes listed for Whirlpool ranges. Which ones a unit can show depends on its control board, so we confirm by the full model number.
Other Whirlpool range models
RangeWEG515S0FV30-inch gas slide-in range
RangeWEG515S0LBGas slide-in range
RangeWEG750H0HBGas slide-in range
RangeWEG995H0FSlide-in gas range
RangeWEGA25H0HNGas slide-in range
RangeWFC110M0AW30-inch coil electric range
RangeWFC130M0AWWhite coil electric range, manual-clean
RangeWFC150M0EBFreestanding electric rangeYWFES7030SW questions
A burner stays hot after I switch the knob off. What should I do?
Switch the range off at the breaker and do not use that burner. A stuck burner switch is the likely cause, and we test and replace it before the range returns to service.
Why does my oven heat slowly?
If only one of the two oven elements works, or the sensor reads low, preheat takes much longer. We test both elements and compare the sensor with a thermometer.
The knob spins but nothing changes. Is the switch bad?
It could be the knob, its stem or the switch shaft. We pull the knob and check how it seats on the shaft, a quick test before replacing any switch.