Whirlpool YWGE745C0FH repair
Free-standing electric range. Service for this model across Tampa Bay.

- Model
- YWGE745C0FH
- Type
- Free-standing electric range
- Brand
- Whirlpool
About the YWGE745C0FH
The YWGE745C0FH is electric and free-standing: it sits on the kitchen floor, is fed by a 240-volt receptacle and has no gas connection. Four endings are listed for the number, including YWGE745C0FH0, YWGE745C0FH1 and YWGE745C0FS0.
A surface element that shuts itself off and on while a pot is cooking is a sign we check carefully. It can be a failing coil, a switch with worn contacts or a receptacle hot enough to break contact, so we test each separately and look for heat marks on the terminals. In the oven, a gap between the display and the actual temperature sends us to the sensor and door seal. When a repair would cost more than the range is worth, we tell you.
What we check on a YWGE745C0FH visit
- Surface element that cycles off and on by itself
- Oven that does not reach the temperature on the display
- Bake element terminals that look burned, plus a door gasket that is hard, flat or torn
Key features
- Free-standing electric range
- Also sold as YWGE745C0FH0, YWGE745C0FH1, YWGE745C0FS0
- Four listed revision endings
The model number is on the data label: inside the door frame, on the drawer edge or behind the kick plate. We are an independent repair company, not affiliated with Whirlpool Corporation.
Whirlpool range codes
Codes listed for Whirlpool ranges. Which ones a unit can show depends on its control board, so we confirm by the full model number.
Other Whirlpool range models
RangeWEG515S0FV30-inch gas slide-in range
RangeWEG515S0LBGas slide-in range
RangeWEG750H0HBGas slide-in range
RangeWEG995H0FSlide-in gas range
RangeWEGA25H0HNGas slide-in range
RangeWFC110M0AW30-inch coil electric range
RangeWFC130M0AWWhite coil electric range, manual-clean
RangeWFC150M0EBFreestanding electric rangeYWGE745C0FH questions
What makes a burner switch itself off and back on?
A failing element coil, a worn burner switch or an overheating receptacle can each make a burner drop out and return. We test them in turn and check the terminals for heat damage.
Could the oven sensor be to blame?
We compare the oven temperature on a thermometer with the display and check sensor resistance. A wide gap with a healthy element points to the sensor.
Do the FH0 and FS0 endings differ?
They separate finishes and revisions, and some switches and controls differ across them. The plate on your unit settles which parts fit.