Whirlpool YWGE755C0BH repair
30-inch freestanding electric range. Service for this model across Tampa Bay.

- Model
- YWGE755C0BH
- Type
- 30-inch freestanding electric range
- Brand
- Whirlpool
About the YWGE755C0BH
YWGE755C0BH is a 30-inch electric freestanding range, the standard cutout width, powered from a 240-volt outlet behind it. Six endings are listed, running from YWGE755C0BH0 to YWGE755C0BH2 and others.
We check a range this width at its familiar wear points. A burner stuck on high suggests a failed switch. Uneven oven heat points to a weak element or a sensor that is off. The back panel and cord connection matter as well, since a range pulled out for cleaning can end up with loosened wiring at the terminal block. With six endings listed, the plate on the range is our guide to the right parts, and we explain the cost before beginning.
What we check on a YWGE755C0BH visit
- Oven that heats unevenly from side to side
- Burner that stays on high whatever the knob says
- Oven light that fails or flickers, plus back panel connections loosened by moving the range
Key features
- 30-inch wide electric range
- Freestanding
- Six listed revision endings
- 240-volt household supply
The model number is on the data label: inside the door frame, on the drawer edge or behind the kick plate. We are an independent repair company, not affiliated with Whirlpool Corporation.
Whirlpool range codes
Codes listed for Whirlpool ranges. Which ones a unit can show depends on its control board, so we confirm by the full model number.
Other Whirlpool range models
RangeWEG515S0FV30-inch gas slide-in range
RangeWEG515S0LBGas slide-in range
RangeWEG750H0HBGas slide-in range
RangeWEG995H0FSlide-in gas range
RangeWEGA25H0HNGas slide-in range
RangeWFC110M0AW30-inch coil electric range
RangeWFC130M0AWWhite coil electric range, manual-clean
RangeWFC150M0EBFreestanding electric rangeYWGE755C0BH questions
My burner stays on high at every knob setting. Why?
The burner switch has probably failed and is passing full power. Turn the range off at the breaker; we test and replace the switch, then confirm every heat setting works.
The oven burns one side of the food. What do you check?
Uneven heat can come from a weak bake element or a sensor reading wrong. We test element resistance and the sensor, and check rack position and door fit.
Is the oven light part of the repair?
Yes, if it is out or flickering we check bulb, socket and switch. It is a small repair that fits into the same visit.