Whirlpool YWSES5030SW repair
Free-standing electric range. Service for this model across Tampa Bay.

- Model
- YWSES5030SW
- Type
- Free-standing electric range
- Brand
- Whirlpool
About the YWSES5030SW
YWSES5030SW is a free-standing electric range on a 240-volt supply with no gas connection, and one ending, YWSES5030SW0, is listed for the number. It is a practical choice for rentals and starter homes and is straightforward to service.
We start with the elements and the receptacles holding them. An element that tilts or sits unevenly may be worn at the plug end, and burn marks around the opening show poor contact. If the oven will not start from the control, we trace power from the outlet through the control to the bake element. A broil element warming only the top rack suggests a partial failure. Since only YWSES5030SW0 is listed, checking the plate is quick.
What we check on a YWSES5030SW visit
- Burner element that tilts or sits unevenly in its receptacle
- Oven that does not turn on from the control
- Broil element warming only the top rack, plus burn marks around the element openings
Key features
- Free-standing electric range
- Single revision listed: YWSES5030SW0
- Plugs into a 240-volt outlet
The model number is on the data label: inside the door frame, on the drawer edge or behind the kick plate. We are an independent repair company, not affiliated with Whirlpool Corporation.
Whirlpool range codes
Codes listed for Whirlpool ranges. Which ones a unit can show depends on its control board, so we confirm by the full model number.
Other Whirlpool range models
RangeWEG515S0FV30-inch gas slide-in range
RangeWEG515S0LBGas slide-in range
RangeWEG750H0HBGas slide-in range
RangeWEG995H0FSlide-in gas range
RangeWEGA25H0HNGas slide-in range
RangeWFC110M0AW30-inch coil electric range
RangeWFC130M0AWWhite coil electric range, manual-clean
RangeWFC150M0EBFreestanding electric rangeYWSES5030SW questions
Why does my burner element sit crooked?
The plug end of the element may be bent or the receptacle worn. We replace whichever is damaged so the element sits flat and makes firm contact.
The oven will not start from the control. What do you check?
Power at the range first, then the control, then the bake element. Finding where power stops tells us which part to replace.
Is this range worth repairing?
In many cases, yes, when the cause is an element, switch or receptacle, since those repairs are simple. We give a written price first and tell you if the cost does not make sense.