Whirlpool WED4720RW repair
Electric vented dryer, white. Service for this model across Tampa Bay.

- Model
- WED4720RW
- Type
- Electric vented dryer, white
- Years
- Current model
- Brand
- Whirlpool
About the WED4720RW
White finish, electric heat and a vented design describe the WED4720RW, a current Whirlpool dryer with timed and automatic cycles plus a wrinkle shield option. The WED4720RW0 revision is the version listed for it.
When an automatic cycle ends with damp laundry, the moisture sensor strips inside the drum get cleaned and tested first, since softener leaves a film on them. The vent comes after that, because a hose pinched behind the cabinet slows every load. A drum that will not start sends us to the door switch. A drum that spins cold means a meter on the heating element and thermal fuse.
What we check on a WED4720RW visit
- Moisture sensor strips after an automatic cycle leaves damp loads
- Vent hose for kinks or crushing behind the cabinet
- Door switch, heating element and thermal fuse with a meter
Key features
- Electric vented drying
- Timed and automatic cycles
- Wrinkle shield option
- White finish
The model number is on the data label: inside the door frame, on the drawer edge or behind the kick plate. We are an independent repair company, not affiliated with Whirlpool Corporation.
Whirlpool dryer codes
Codes listed for Whirlpool dryers. Which ones a unit can show depends on its control board, so we confirm by the full model number.
Other Whirlpool dryer models
WED4720RW questions
Loads are damp after the automatic cycle. What gets checked?
The sensor strips are cleaned and tested, then airflow through the vent is measured. A softener film ends cycles early, while a restricted vent leaves clothes wet even after a full run.
Why would the drum refuse to start when I press the button?
The door switch is tested first, then the start switch and thermal fuse. Each gets a meter test so only the part that failed is replaced.