Whirlpool WED5010LW repair
Electric dryer with AutoDry sensing. Service for this model across Tampa Bay.

- Model
- WED5010LW
- Type
- Electric dryer with AutoDry sensing
- Brand
- Whirlpool
About the WED5010LW
Moisture sensing on equipped variants, a wrinkle shield option and a white cabinet set the WED5010LW apart as an electric Whirlpool dryer. Like any vented electric unit, it depends on a clear exhaust path to the outside.
Airflow is where a visit starts. A restricted duct pushes cabinet temperature up until the thermal cut-outs stop the heat, so the dryer seems to start, stop and ask for a second cycle. With the air moving properly, we clean the sensor strips and put a meter on the heating element. A thump once per drum turn points at a worn roller, while a squeal could be the idler or the belt.
What we check on a WED5010LW visit
- Vent airflow and the thermal cut-outs that react to heat buildup
- AutoDry sensor strips for lint and softener film
- Heating element continuity, plus drum roller and belt condition
Key features
- Electric vented dryer
- AutoDry moisture sensing on equipped variants
- Wrinkle shield option
- White cabinet
The model number is on the data label: inside the door frame, on the drawer edge or behind the kick plate. We are an independent repair company, not affiliated with Whirlpool Corporation.
Whirlpool dryer codes
Codes listed for Whirlpool dryers. Which ones a unit can show depends on its control board, so we confirm by the full model number.
Other Whirlpool dryer models
WED5010LW questions
Why does one load need two cycles?
A restricted vent lets heat build until the cut-outs interrupt the cycle. Airflow gets measured and the duct cleared, then the sensor strips and heating element are tested if the problem remains.
How can I tell if the AutoDry sensing is working?
Switch the dryer off and unplug it, wipe the strips with a cloth and a little rubbing alcohol, then run a small load. If cycles still end too soon or run on, the wiring or control needs testing on site.