Whirlpool WGD4810BQ repair
29-inch gas dryer. Service for this model across Tampa Bay.

- Model
- WGD4810BQ
- Type
- 29-inch gas dryer
- Brand
- Whirlpool
About the WGD4810BQ
Two machines that look the same can take different parts when the model is the WGD4810BQ, a 29-inch gas Whirlpool dryer that also turns up as WGD4810BQ0 and WGD4810BQ1.
A dryer this wide is often swapped in for a narrower one in a garage corner or a laundry room with a rear gas stub-out. When one tumbles without heat, we watch the start-up: igniter glow, valve click, flame. If the flame drops out mid-load, a weak coil or a vent that cannot clear exhaust is the likely cause. The lint in the run behind a wide cabinet is cleared, and the gas shutoff and flex connector at the back panel are examined.
What we check on a WGD4810BQ visit
- Igniter glow versus burner ignition, and gas valve coil behavior mid-cycle
- Lint in the vent run behind the cabinet
- Gas shutoff and flex connector, drum rollers and belt
Key features
- 29-inch width
- Gas dryer
- Number appears with 0 and 1 endings
The model number is on the data label: inside the door frame, on the drawer edge or behind the kick plate. We are an independent repair company, not affiliated with Whirlpool Corporation.
Whirlpool dryer codes
Codes listed for Whirlpool dryers. Which ones a unit can show depends on its control board, so we confirm by the full model number.
Other Whirlpool dryer models
WGD4810BQ questions
My gas dryer lights, then goes out a minute later. What is happening?
A restricted vent, a tired gas valve coil or a flame sensing part. Airflow is tested first, since heat trapped in the cabinet shuts the burner down.
Can a 29-inch gas dryer be repaired in a garage closet?
Yes, provided it can be pulled forward to reach the back panel, gas connector and vent. The connector is checked for leaks and the duct for lint before the dryer goes back.