Whirlpool WGD8300SB repair
Gas dryer. Service for this model across Tampa Bay.

- Model
- WGD8300SB
- Type
- Gas dryer
- Brand
- Whirlpool
About the WGD8300SB
The WGD8300SB is a Whirlpool gas dryer that also shows up as WGD8300SB0. It is serviced like any gas dryer: by following the path from gas supply to flame.
A glowing igniter with no flame is the case that comes up most. The valve coils may not be opening, the gas may be off at the shutoff, or the flame sensing part may be failing. Heat that appears and disappears can trace to a coil that fails once warm, so these parts are tested hot as well as cold. Long drying times tie to the vent more than the burner, so the duct is cleared and measured on the same visit.
What we check on a WGD8300SB visit
- Gas shutoff, flame sensing and valve coils when the igniter glows but the burner stays dark
- Coil and thermostat behavior when warm
- Vent length and lint buildup
Key features
- Whirlpool gas dryer
- Sold under the WGD8300SB0 ending
The model number is on the data label: inside the door frame, on the drawer edge or behind the kick plate. We are an independent repair company, not affiliated with Whirlpool Corporation.
Whirlpool dryer codes
Codes listed for Whirlpool dryers. Which ones a unit can show depends on its control board, so we confirm by the full model number.
Other Whirlpool dryer models
WGD8300SB questions
The igniter glows but there is no flame. Is the igniter bad?
Not always. A glowing igniter only shows it works; the valve must still open. Gas supply is checked and the coils tested to learn which part failed.
Why does the heat come and go?
A valve coil or thermostat that fails when hot can interrupt the burner, so those are tested warm and not only at room temperature.